G2 Ergonomics Throttle Cam System

Features:

Machined from 6061 aluminum in the USA!
Self-lubricating Delrin bushings at each end of tube eliminate aluminum-to-aluminum contact and provide an ultra-smooth feel
Alternate cams to fine tune control sold separately
Fits inside the stock throttle housing to stock cables
Removable end cap for simple handguard installation

Installs in minutes!

The Throttle Cam System incorporates a non-linear ratio between hand throttle rotation and carburetor or throttle body opening. The “pulley”, or as we call it, “cam” pulls the throttle cable as the rider rotates the grip/tube. By altering the conventional, circular shaped cam, a vast improvement in control is achieved.

The Throttle Cam System has cam options with reduced radius for the first ½ of throttle rotation, which requires a slightly farther turn to achieve the same carburetor or throttle body opening position as a stock throttle. This slightly longer pull makes a HUGE difference in rider control as the power is rolled on. The system comes with a “100CAM” – same as stock, “200CAM” – starts out 10% smaller than stock and “400CAM” – starts out 20% smaller than stock. The radius of the 200CAM and 400CAM increases or “ramps up” to stock size at ½ throttle to keep overall rotation required to reach full throttle at or near stock rotation.

G2 Ergonomics Throttle Cam System

Was:	~~$109.95~~
Now:	$104.45

The G2 Ergonomics Throttle Cam System is a regularly stocked item ready for shipping in USA only.

Other Related Products ...

G2 Ergonomics Aluminum Throttle Tube

Works Connection Aluminum Throttle Tube

Motion Pro Replacement Throttle Tube